PRO WHEELS MULTIPRODUCT BOX

PRECAUTIONS

• Apply in temperatures between 10-30°C, 50-90°F.
• Apply in a closed, well ventilated, indoor area with air humidity not exceeding 70%
• Clean spray gun with PRO SOLVENT SPRAY (Spray Gun Cleaner) between products and immediately after applying PRO HYDRO SPRAY to avoid any permanent damage to the spray gun.
• Must wear protective gloves and appropriate respirator.

WHAT YOU’LL NEED

• 2 Microfiber Towels
• Spray Gun & Diamond ProTech Adapter
• Protective Gloves
• Respirator Mask
• Diamond Body Prep

APPLICATION TIPS

• Appropriate for metal surfaces which experience high-heat. As the coating bonds to the surface a haze will appear. This indicates coating is ready to be removed. If the product dries on the surface or is difficult to remove, re-wet the area with more product and immediately buff off.
• For a faster curing of PRO WHEELS SPRAY we suggests using IR Drying lamps

IR CURING LAMP INSTRUCTIONS:

• Temperature: 50-60°C / 120-140°F
• Distance to bodywork: 60-70 cm / 24-28 inches.
• Time: 10-15 minutes for each section.

INSTRUCTIONS

• Prepare the wheels by washing, then treat with Diamond Body Prep.
• Shake the bottle of PRO WHEELS SPRAY for 15 seconds. Connect the bottle to the Diamond ProTech adapter and then to the IWATA LPH-80 spray gun.
• Proceed to spray PRO WHEELS SPRAY evenly over all parts of the wheel. Partially overlap each pass over the previous one to insure full coverage.
• Wait 3-5 mins and polish off excess with a low-nap microfiber towel. Allow to cure for 1 hour before using the vehicle.
• Clean the spray gun with SOLVENT SPRAY when finished.

• We recommend that you use an IWATA LPH-80 spray gun with 0.8mm needle.
• Clean spray gun with PRO SOLVENT SPRAY between layers and immediately after applying final layer of coating to avoid any permanent damage to the spray gun
• Recommended spray gun settings:Air nipple – 3.5
• Fluid nipple – 3.5-4.5 (depending on porousness of surface)
• Pressure – 0.1-0.2 BAR