PRECAUTIONS
Apply in temperatures between 10-30C, 50-90FApply in a closed, well ventilated, indoor area with air humidity not exceeding 70%Clean spray gun withSOLVENT SPRAYbetween layers and immediately after applying final layer ofPRO WHEELS SPRAYto avoid any permanent damage to the spray gunMust wear protective gloves and appropriate respirator.
WHAT YOU’LL NEED
2 Microfiber TowelsSpray Gun & DIAMOND PROTECH AdapterProtective GlovesRespirator MaskDIAMOND PRO TECH
APPLICATION TIPS
Appropriate for metal surfaces which experience high-heat.As the coating bonds to the surface a haze will appear. This indicates coating is ready to be removed.If the product dries on the surface or is difficult to remove, re-wet the area with more product and immediately buff off.
For a faster curing of PRO WHEELS SPRAY we suggests using IR Drying lamps
IR Curing Lamps settings:
Temperature: 50-60°C / 120-140°F
Distance to Wheel Rims: 60-70 cm / 24-28 inches
Time: 10-15 mins
INSTRUCTIONS
Prepare the wheels by washing, then treat withDIAMOND BODY PREP.Shake the bottle ofPRO WHEELS SPRAYfor 15 seconds.Connect the bottle to the Diamond ProTech adapter and then to the IWATA LPH-80 spray gun.Proceed to sprayPRO WHEELS SPRAYevenly over all parts of the wheel. Partially overlap each pass over the previous one to insure full coverage.Wait 3-5 mins and polish off excess with a low-nap microfiber towel.Allow to cure for 1 hour before using the vehicle.Clean the spray gun withSOLVENT SPRAYwhen finished.
FOR APPLICATION YOU NEED SPRAYGUN
We recommend that you use an IWATA LPH-80 spray gun with 0.8mm needle. Clean spray gun with SOLVENT SPRAY between layers and immediately after applying final layer of coating to avoid any permanent damage to the spray gun
Recommended spray gun settings:
Air nipple – 3.5
Fluid nipple – 3.5-4.5 (depending on porousness of surface)
Pressure – 0.1-0.2 BAR